Danfoss living connect Wartungshandbuch PDF herunterladen

DAN_LC-13

Z-Wave Radiator Valve

Thermostat (013)

Firmware Version : 3.48

Quick Start

This device is a Z-Wave Radiator Thermostat. Click on the middle button will confirm inclusion or

exclusion and wakeup the device for wireless communication. A long push for 3 seconds on the middle

buttons enters and leaves the management mode indicated by a 'M' on the LCD display.

Please refer to the chapters below for detailed information about all aspects of the products usage.

What is Z-Wave?

This device is equipped with wireless communication complying to the Z-Wave standard. Z-Wave is the

international standard for wireless communication in smart homes and buildings. It is using the

frequency of 868.42 MHz to realize a very stable and secure communication. Each message is reconfirmed

(two-way communication) and every mains powered node can act as a repeater for other nodes (meshed

network) in case the receiver is not in direct wireless range of the transmitter.

Z-Wave differentiates between Controllers and Slaves. Slaves are either sensors (S) transmitting metered or

measured data or actuators (A) capable to execute an action. Controllers are either static mains powered

controllers (C) also referred to as gateways or mobile battery operated remote controls (R). This results in a

number of possible communication patterns within a Z-Wave network that are partly or completely supported

by a specific device.

Controllers control actuators

1 2 3 4 5 6 7

Inhaltsverzeichnis

Seite 1 - Thermostat (013)

DAN_LC-13Z-Wave Radiator Valve Thermostat (013)Firmware Version : 3.48Quick StartS This device is a Z-Wave Radiator Thermostat. Click on the middle bu

Seite 2 - Installation Guidelines

2.Actuators report change of status back to controller3.Sensors report change of status of measured values to controller4.Sensors directly control act

Seite 3

Adjustment to the radiator The device can be adjusted to the room size. Three room sizes are known. The default size is P1. To change the assumed room

Seite 4 - Operating the device

Operating the deviceThe Danfoss device is operated by wireless commands from a Z-Wave controller. It is operated in two different modes:Direct setting

Seite 5 - Node Information Frame

When the battery level is low, the alarm bell icon flashes and the display will flash 8 times an hour between 19 and 22 hrs. If the battery goes flat,

Seite 6 - Technical Data

A Z-Wave devices control other Z-Wave devices. The relationship between one device controlling another device is called association. In order to contr

Seite 7 - Disposal Guidelines

Controller — is a Z-Wave device with capabilities to manage the network. Controllers are typically Gateways, Remote Controls or battery operated wall