Danfoss TS715 Si Bedienungsanleitung PDF herunterladen (Seite 4)

 The wallplate must be securely mounted either directly to

the wall using suitable wood screws or to a ﬂ ush mounted

1-gang electrical accessory box using M3.5 screws.

 Cable access can either be from behind for concealed

cabling, or from below for surface cabling. If surface cable

is used, cut out cable access slot on plug-on module prior

to mounting the module.

 For wiring connections refer to diagram on page 5.

TS715-Si models are double insulated and do not require

an earth connection, however a parking terminal is

provided on the wallplate. This is clearly marked with an

Earth symbol.

 Prior to mounting the plug-on module, DIL switches on

the rear of the plug-on module must be set. See diagram

on page 5 for available options.

 Mount plug-on module to wallplate by locating tabs on

top of wallplate in apertures on rear of module, hinge

down and press ﬁ rmly to wallplate before tightening

securing screws on bottom of wallplate.

Installation and Wiring

Wiring (For Wiring Conversion tables see pages 8-11)

COM

OFF

230 V

fused 3A

TS715 (3066 12/01)

Always switch oﬀ mains ﬁ rst and never ﬁ t programmer

to a live wallplate.

NOTE:

Link terminals L

and 1 for standard

mains voltage

operated systems

On 24 volt models

power supply must

be wired to A & B on

wallplate.

1 2 3 4 5 6 7 8 9 ... 31 32

Keine Kommentare

Danfoss TS715 Si Bedienungsanleitung Seite 4