Danfoss TripleLynx CN Installationshandbuch PDF herunterladen (Seite 216)

Solar-Log1000: Configuration at the unit

Changing the network settings (Basic/Network)

216 of 268 Solar-Log

1000/500/200

Installation

10.5.3 Analogue modem settings

If internet access by analogue modem has been selected, the access data of

the telephone service provider must be entered here.

Dialogue boxes

 Internet-by-call No., user name, password

This is preset to Internet-by-call access through Arcor. This can be modi-

fied as necessary.

 Predial “0”

In certain telephone systems, a “0” has to be dialled before dialling the ac-

tual telephone number.

 Dial tone Off

In a standard modem, the dialling process is audible; this provides a good

initial testing function until the connection is established. The dial tone can

then be switched off.

If there are problems with the internet connection, the best solution is to

check the line with a conventional telephone to determine whether the tel-

ephone connection is working or is disconnected. In this way, you can find

out quickly and easily whether it is necessary to predial “0”.

 Allow dial in

Solar-Log

1000

generally allows dial up if an analogue modem is used. This

means that the Solar-Log

1000

can be dialled up from outside using a PC

and another modem, if this has been enabled.

 Password

The factory-set password is “solarlog” - this should be changed.

Procedure

1 Enter all the relevant data (see above list)

2 Touch Save, then Next to go to the next dialogue.

1 2 ... 211 212 213 214 215 216 217 218 219 220 221 ... 267 268

Keine Kommentare

Danfoss TripleLynx CN Installationshandbuch Seite 216