Danfoss ECtemp 535 Installationsanleitung

MAKING MODERN LIVING POSSIBLEInstallation GuideECtemp 535Electronic Thermostatwww.EH.danfoss.com

The screen of the heating cable must be connected tothe earth conductor of the power supply cable by us-ing a separate connector.Note: Always instal

3 SettingsSensor: How to specify whether an external floor sen-sor, the built-in room sensor or both is used to controlthe floor heatingNote: The floo

If both a room sensor and a floor sen-sor is used, choose:This option is suitable for all roomsbut wet rooms. The thermostat mustbe installed in the

How to set the maximum floor temperatureSpecial condition: This setting only applies if a floor sensoris used (the floor sensor or room/floor sensor o

Note: Please contact the floor supplier before changing themaximum floor temperature and be aware of the following:▪The floor temperature is measured

How to define the temperature scaleSpecial condition: If floor sensor is selected, the numericalscale with steps from 1 - 6 must be selected.Note: By

5 Disposal InstructionECtemp 53516 Installation Guide

ECtemp 535Installation Guide 17

ECtemp 53518 Installation Guide

ECtemp 535Danfoss A/SElectric Heating SystemsUlvehavevej 617100 VejleDenmarkPhone:+45 7488 8500Fax: +45 7488 8501Email: [email protected]

ECtemp 535 ELKO088L0042Timer ThermostatFloor/Room Sensor220-240V~50-60Hz~+5 to +45°C15A/3450W@230V~IP 31Product DocumentationDesigned in Denmark for D

Table of Contents1 Introduction ... 31.1 Technical Specifications ... 41.2 Safety Instructions ... 62 Mounting Instructions ...

The thermostat has buttons for adjusting the temperaturesetting, and a LED indicator showing standby periods(green light) and heating periods (red lig

Temperature range 5-35°C with room sensor5-45°C with floor sensor onlyFloor max 20-50°CFloor min 10-35°C, when instal-led with combination of roomand

1.2 Safety InstructionsMake sure the mains supply to the thermostat is turned offbefore installation.IMPORTANT: When the thermostat is used to control

2 Mounting InstructionsPlease observe the following placement guidelines:Place the thermostat at a suitable heighton the wall (typically 80-170cm.).Th

Do not place the thermostat in a way thatit will be exposed to direct sunlight.Note: A floor sensor enables a more accu-rate temperature control and i

Follow the steps below to mount the thermostat:1. Open the thermostat: devireg™550devireg™550D▪Gently press the release tab in the bottom of thethermo