Danfoss RZ1 Bedienungsanleitung PDF herunterladen (Seite 14)

RZ1 AND RZ1HP

Basic Support

Binary switch Support

Association Control

Multi-Channel Vn2 Support

Multi-Channel Association Vn2 Control

Multi-command Control and Support

Protection Vn2 Support

Version Support

Wakeup Control

Thermostat Set Point Support

Manufacturers Specic Support

8.0 Z-Wave supported and controlled classes

7.0 Factory Reset

If for any reason you need to return the RZ1 unit to its factory reset

state, or you need to wipe all network information from the unit it is

advisable to perform a factory reset.

1. Press PROG to place the receiver in PROGRAMME mode (Red

LED illuminated continuously).

2. Press and hold CH1 button for at least 15 seconds.

3. The PROG LED will ash rapidly orange and green. Press and

hold down the PROGRAMME button for at least 15 seconds.

4. If reset was successful, the channel LEDs will show as RED and

the PROG LED will ash slowly green to indicate that the unit is

now in its factory reset state.

* If after step 1, the PROG button is not held down within 30 seconds,

the unit will return to its previous state and the full reset will not have

been applied.

1 2 ... 9 10 11 12 13 14 15 16

Keine Kommentare

Danfoss RZ1 Bedienungsanleitung Seite 14