Danfoss VLT 5000 FLUX Wartungshandbuch PDF herunterladen (Seite 29)

MG.10.Q1.5B – VLT is a registered Danfoss trade mark

VLT 5000/5000 FLUX SyncPos Quick-Setup

SW 1.1: Connect(ON)/disconnect(OFF) 24 V from control card (see description of supply voltages).

SW 1.2: Connect(ON)/disconnect(OFF) 24 V common from control card.

SW 1.3: Connect(ON)/disconnect(OFF) termination resistor for master encoder (see description of virtual

master function).

Note: When OFF the master encoder monitor is disabled.

SW 1.4: Switch Z-channel encoder monitor ON/OFF for both master and slave.

Default setting of switch 1.1. - 1.4 is ON.

■■

■ Option card layout:

Option card layout showing the position of connectors and dip switch.

5V monitor:

LED off = no 5V

LED Green = 5V ok.

CPU monitor:

LED must flash at 1 Hz to

indicate a running CPU system

Encoder monitor master,

channel A, B and Z:

LED off = Short or open circuit

LED green = Ok.

Encoder monitor slave,

channel A, B and Z:

LED off = Short or open circuit

LED green = Ok.

Technical Data/Wiring examples

1 2 ... 24 25 26 27 28 29 30 31 32 33 34

Keine Kommentare

Danfoss VLT 5000 FLUX Wartungshandbuch Seite 29