Danfoss VLT 8000 AQUA Installationsanleitung PDF herunterladen (Seite 39)

VLT® 8000 AQUA

Installation

■ Infinitely variable change of numeric data value

If the chosen parameter represents a numeric data

value, a digit is first selected by means of the [<>] keys.

175ZA699.10

SETUP

50.0 Hz

FREQUENCY

209 JOG FREQUENCY

9 .0 Hz

SETUP

Then the chosen digit is changed infinitely by

means of the [+/-] keys:

175ZA700.10

SETUP

50.0

FREQUENCY

209 JOG FREQUENCY

0.0 Hz

SETUP

The chosen digit flashes. The bottom display

line shows the data value that will be entered

(saved) when signing off with [OK].

■ Changing of data value, step-by-step

Certain parameters can be changed both step by

step and infinitely variably. This applies to Motor

power (parameter 102), Motor voltage (parameter

103) and Motor frequency (parameter 104).

This means that the parameters are changed

bothasagroupofnumericdatavaluesandas

numeric data values infinitely variably.

■ Manual initialization

Disconnect from line and hold the [DISPLAY MODE] +

[CHANGE DATA] + [OK] keys down while at the same

time reconnecting the line supply. Release the keys; the

AFD has now been programmed for the factory setting.

The following parameters are not zeroed by means of manual

initialization:

Parameter 500, Protocol

600, Operating hours

601, hours run

602, kWh counter

603, Nu mber of powe r-ups

604, Numbe r of overtemperatures

605, Num ber of over voltages

It is also possible to carry out initialization via

parameter 620 Operating mode.

MG.80.A6.22 - VLT is a registered Danfoss trademark

1 2 ... 34 35 36 37 38 39 40 41

VLT® 8000 AQUA 1

Kommentare zu diesen Handbüchern

Keine Kommentare

Danfoss VLT 8000 AQUA Installationsanleitung Seite 39

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Danfoss VLT 8000 AQUA